Operating instructions 4123
Flexproof-Cutter
AF-61/8x30
Page
8
of
14
Edition: 01/0206
Subject to alterations
5. Service
5.1 Preventive
Maintenance
Keep the cutting pad (2) clean at all times. Clean it regularly and remove material residues.
Check the cutting blades (26) periodically for their sharpness and replace with the correct type if
necessary.
Slightly lubricate the hinge of the preparing device with oil at periodic intervals.
See also checklist and record sheet enclosed.
5.2
Replacement of cutting blades
Remove the base plate (1) unscrewing the four screws.
Remove the two screws which fix the blank holder (13) and remove it.
Remove the four screws which fix the two blades (26).
Remove the blades (26).
WARNING
Handle cutting blades with special care. The blades can cause injury even if they
are worn out.
Replace the cutting blades making the same operations in reverse order.
CAUTION
Be sure not to damage blade edges.
5.3
Replacement of the cutting pad
Remove the base plate (1) unscrewing the four screws.
Replace the cutting pad (2).
Fix the base plate.
4123INS.FAB-en0306ITA
