User Guide
TGT. 12.03.2019
Technical
Page 6 of 21
©Copyright by Habegger Maschinenfabrik AG
Version 03 / 12.03.2019
1
General specifications
The motor-driven rope pulling machine HIT-TRAC 128 is designed for pulling, hoisting and lowering loads.
1.1
Drive mechanism
A special HABEGGER steel cable of desired length which is guided over the relevant guide elements by the driving wheel and
then ejected in an unloaded state is used as the drive mechanism.
1.2
Housing cover
The removable cover on the driving wheel prevents the entry of foreign objects and protects against accidents resulting from
improper access. There is also an anti-derailment device for the traction cable integrated into the housing cover.
-
Close and secure the housing cover over the driving system before carrying out any work.
1.3
Rope
The machine is equipped for rope diameters of 28 mm in the factory:
This rope is suitable for all hoisting, pulling and lowering work.
-
Only suitable, original HABEGGER ropes should be used.
1.4
Operation
The machine is powered using a 3-phase rotary current motor
1.5
Electrical control system
Speed control
The machine is fitted with a speed control.
The frequency converter and the control system are securely fixed inside the electrical box. The input comes from a plug for
three-phase A.C. current along a 5m long supply cable. Also connected to the control box, via a 5m long control cable, is a
pendant station with the control buttons UP/DOWN, the emergency stop button and a potentiometer for speed control.
Customised models
For special purposes a control cable or a radio control can be attached. On these occasions even closer attention should be
paid to the rope pulling machine during hoisting and lowering. The empty rope’s free exit and entry must be guaranteed.
