34
MODE to enter the program of F
—1, F—2, F—3, F—4, F—5 (F—1:gender, F—2:age,
F
—3:height, F—4:weight, F—5:physical test), Press
SPEED
+/
SPEED
- or INCLINE +/
INCLINE to set the parameter of 01-04(see below detailed table), then press MODE to
enter the program of F
—5 for physical test. At this state, hold the handle pulse board for 5-6
seconds and it will display the FAT, check if the weight matches with your height.
FAT is to measure the relevance between height and weight, not the body proportion.
FAT is suitable for every man and woman, it provide the important grounds for adjusting the
weight with other health indicators. The perfect FAT is between 20-24, which means if less
than 19 is too thin, and if between 25-29 is overweight and if more than 30 is obesity.
F--1
Gender
01(man)
02(woman)
F--2
Age
10------------99
F--3
Height
100----------200
F--4
Weight
20------------200
F--5
FAT
≦
19
Underweight
FAT
=(20--24)
Normalweight
FAT
=(25--29)
Overweight
FAT
≧
30
Obesity
1.11. Others
1.11.1.
When a countdown parameter run off, display "END", the alarm rings 0.5s every 2s,
until the treadmill full stop, then return to manual mode.
1.11.2.
In setting a parameter, it can be roop-setting, for example, time range is
5:00--99:00, when set at 99:00, press "+" key, the time return to 5:00, and so on
recirculation, add or reduce by “+”“—”symbol.
1.11.3.
Countdown time, countdown calorie and countdown distance can only be set up for
one of them. The last time setting will be implemented. The parameter set will be counted
backwards while other parameters will be counted forwards.
1.11.4.
The standard calorie is about 30kcal/km.
1.11.5.
The acceleration is 0.5Km/S and the deceleration is 0.5Km/S.
1.11.6.
MP3 music audio amplification, input from the enter hole by the side.
1.11.7.
In the process the un-set parameter will be up cumulative, the display clear when up
to the max range; in the manual mode when the time accumulation excess 99:59(100min)
the treadmill stops.
1.12. Meanings of error message codes
Problem
Potential reasons
Solutions
-------
Safe lock falls down
1. Place back the safe lock;
2. Replace safe lock switch or magnetic sensor in the
electronic meter; if the problem still fails to be solved, replace
the electronic meter;
