11
Device Pairing
The HTE-01 Thermostat and the HTM-01 Base Module that were shipped
together were paired at the factory for convenience. To add additional
base modules, use the following procedure.
1.
Hold down the Fan, Mode, and
buttons for more than 3
seconds to initiate the Pairing
process on the HTE-01 Thermostat
and set the 10-minute countdown
timer in action. This will allow
pairing of up to eight base
modules.
Note: To exit the Pairing process
hold the “Mode” and “Fan” button
until a beep is played.
2.
To initiate the Pairing process on
each HTM-01 base module, press
and hold the PAIR button for
between 3 & 10 seconds until the
connection status LED flashes
green. The table on page 7 shows
the HTM-01 base module State
that corresponds to the LED Status
Indication.
Status LED
PAIR Button