The Multiprobe Files Submenu
Page 24
Logging and Data Transfer
•
ASCII: Text will transfer the stored files as straight text files.
•
XMODEM: Text will also transfer files as text files, using the XMODEM communications
protocol.
•
XMODEM: Binary is for factory diagnostics only.
5.
Launch the communications program and make sure the baud rate for the computer and the
proper transfer protocol is selected in the communications program setup menus.
6.
Select the appropriate downloading process sequence and press any key on the Surveyor 4a.
7.
When finished, press any key on the Surveyor 4a.
4.4 The Multiprobe Files Submenu
4.4.1 Creating a File
Note:
If creating files with a Series 3 Sonde, and temperature as a parameter was selected, both °C and °F
will be included in the file. If SpCond:mS/cm was selected, SpCond:µS/cm, Res, and TDS are included the
file. If Depth was selected, both Depth:Meters and Depth:Feet will be included in the file. If DO%Sat was
selected, both DO:%Sat and BP:mmHg will be included in the file. After the transfer process to the PC is
complete, open the file within the PC and erase the unnecessary parameters and readings. Not e that only
the first 80 columns of the file transfers to the computer.
1.
In Series3Sonde or Series4Sonde mode, press Files and press Sonde. In Series3Sonde
mode, the Surveyor 4a will scan for the Sonde.
2.
Highlight Create and press SELECT.
3.
Press SELECT again.
4.
Enter a file name, a file starting time date and time, a file stopping date and time, an interval, a
warm-up time, an audio (or buzzer), a circulator (or stirrer), and a choice of the parameters to
be recorded.
Summary of Contents for 003070HY
Page 2: ......
Page 8: ...Visit us at www hachenvironmental com ...
