Figure 14 Advanced report for sample data—2 lines
1
Probe model
4
Additional units: shows all additional units
associated with the reading.
2
Error message (if applicable)
5
Probe settings: shows the highest-priority setting
associated with the reading
3
Probe serial number (a “<“ or “>” on the HQ40d
meter indicates the probe position)
Figure 15 Total report for sample data—3 lines
1
Method name for probe settings
4
Calibration slope/ratio/constant
2
Time of calibration, prefaced by “CAL” and
displayed as hh:mm in 24 h (or user-defined) format
5
Offset—contents vary depending on type of
parameter and user settings. May be blank.
3
Date of calibration (DD-MM-YY or user-defined
format)
6
Operator ID: user-defined; shows “- - -” if undefined
Check standard reports
Check standard data is printed with 1 line of information (
Figure 16
)
Figure 16 Check standard report
1
Report type (ST = check standard)
5
Measured value
2
Report type (ST = check standard)
6
Units
3
Time (hh:mm:ss in 24 h or user-defined format)
7
Check standard status: Pass/Fail based on the
acceptance criteria
4
Date (DD-MM-YY or user-defined format)
8
Operator ID: user-defined; shows “- - -” if undefined
Calibration reports
Calibration data is printed when the data log is sent to the printer or when probe data is sent to the
printer. Calibration data is printed with 2 lines of information (
Figure 17
).
English
29
Summary of Contents for HQ440d
Page 1: ...DOC022 53 80116 HQ440d HQ430d HQ411d 10 2016 Edition 3 User Manual...
Page 2: ......
Page 34: ......
Page 35: ......
