background image

-the air-speed can be selected in flight on the brakes. Control the gliders speed with the "elevator stick" (brake) carefully.    
Excessive braking caused a stall. 
 

-combined two control functions (for example right and brake), the model reduces its speed and is able to fly flat and uniform 
circles. This achieves the best climbing in weak thermals. WARNING: Excessive brake with simultaneous strong control pulses 
can cause a stall or a spin! 
 

-if from turbulence air one side of the wing is folded in, it opens normally very quickly and the flight can be continued. If the 
Paraglider turns slightly away to the folded side, just slightly compared to control and wait for the opening. 
 

-Fly-active: this is the high art of paragliding. In turbulent air, the canopy sometimes moves back and forth. A moving forward of 
the canopy can be stopped by brake light and the canopy stays clean in its position. This can achieve a significant performance 
gain and collapses are avoided effectively. 

- you can adjust the airspeed of the glider model by the weight of the dummy pilot:: 
less wind / weak updraft = pilot light = low airspeed> 2.4 kg pilot weight 
stronger wind = pilot heavy = more speed = more agile flight characteristics> 2.8 kg pilot weight 

 

 
This model is not a toy, suitable for young people aged 14 years 

 

 

               

                                              

 

 

Hacker Motor GmbH 
Schinderstraßl 32 
D-84030 Ergolding 
 
Geschäftsführer: Rainer Hacker 
 
Registergericht: Amtsgericht Landshut HRB 8052 

 

Kontakt: 
Tel.: +49 871-953628-0 
Fax: +49 871-953628-29 
Email

info@hacker-motor.com

 

 
Ust.Id.Nr.: DE 813554015 
WEEE-Reg.-Nr. DE 55352581  

 

Summary of Contents for STUNT 3.0

Page 1: ...al glider model Please take some time and study carefully the instructions It contains some tips and tricks that will make flying a model glider to a great experience Unpacking Mounting For the first time spread out the glider in a clean room The glider is laid with the top sail on the floor Take the risers and sort the lines in order to avoid rotation or knotting The risers have three rows of lin...

Page 2: ...ing flare If the servos do not run in the correct direction change the two servo connectors on the receiver and or use the reverse function of your transmitter On the brake lines you make a mark with a pen which marks the approximate location for the brake lines of implementation through the top ring IMPORTANT of the C Riser This issue should be put on the brake line 34cm from the first knot in th...

Page 3: ...d be the result Brakes set You are on a slight slope with open fields to front The wind is not too strong and comes straight from the front Transmitter and receiver battery batteries are fully charged the control functions are checked and have correct directions Then go for the first flight The canopy is as with the run tests on the ground All lines especially the brake lines run without twists or...

Page 4: ...ning Fly active this is the high art of paragliding In turbulent air the canopy sometimes moves back and forth A moving forward of the canopy can be stopped by brake light and the canopy stays clean in its position This can achieve a significant performance gain and collapses are avoided effectively you can adjust the airspeed of the glider model by the weight of the dummy pilot less wind weak upd...

Reviews: