background image

 

 

 

 

5.52.695.00.01.04 

 

 

 

  The permissible ambient temperature when operating the devices: 

Type of drive 

Device classification for 

not explosive atmosphere 

Explosive atmosphere 

according to  

 ATEX 

)* )**

 

Manually driven 

-20°C/+50°C 

-20°C/+40°C 

Motor driven 

-20°C/+40°C 

-20°C/+40°C 

 

 

) * At an atmospheric pressure range from 0.8bar to 1.1bar and an oxygen content of approx. 21% 

 

) ** Devices of this category have been specially modified and labeled by the manufacturer

 

 

   

DANGER!

 

The ambient temperature range must not be exceeded! 

 

 

 

 

NOTICE!

 

If the units are not used as intended, safe operation is not guaranteed. 
The operator alone is responsible for all personal injury and damage to property resulting from improper 
use. 

 

2.5 

Basic safety measures 

  Observe installation-, operation and maintenance instruction. 

  Take notice of caution notes at units and in the manual 

  Observe safety distances. 

  Ensure good visibility during operations 

  Use the equipment only for its intended purpose 

  The equipment is only intended for moving goods. Persons must not be moved under any circumstances. 

  Never load the equipment beyond the specified permissible load capacity. 

  Observe the relevant national accident prevention regulations. 

  Should the hoist be used outside of Germany, please pay attention to the national regulations that apply. 

  Building walls, ceilings, floors or constructions - on which the units are mounted or suspended - must be 

checked by a structural engineer for sufficient stability. 

  After  the  unit  has  been  standing  for  a  longer  period  of  time,  visually  inspect  all  components  that  are 

important for its function and replace damaged components with new original spare parts. 

  Do not use a defective unit; listen for abnormal operating noises. 

  In case of malfunctions, stop the operation immediately and rectify the fault. 

  Report damage and defects immediately to a responsible person 

  When working with the unit, warn persons in the immediate vicinity. 

  Observe  the  provisions  for  load  suspension  equipment  in  accordance  with  the  relevant  national 

regulations for the positive and non-positive slinging of loads. 

 

  The sling or load must be securely attached to the load hook and rest on the bottom of the hook. 

  The safety latches of hooks must be closed. 

  The housing must not be in contact with anything. 

 

  Motor drive is prohibited. 

 

 

Transport and Storage 

 

   

CAUTION!

 

Transport  may  only  be  done  by  qualified  personnel.  No  liability  for  any  damage  resulting  from  improper 
transport or improper storage. 

 

3.1 

Transport 

 The devices are checked and if so adequately packed before delivery. 

  Do not throw or drop the equipment.  

  Use adequate means of transport. 

Transport and means of transport must be suitable for the local conditions. 

Summary of Contents for 208/05












Reviews: