www.hadenusa.com
6
USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended
that you clean your kettle before use by boiling a full kettle of
water twice and then discarding the water.
1. Place the kettle on the flat surface.
2. To fill the kettle, open the lid by pressing down on the lid
release button, once filled with the desired amount of water
close the lid.
Always fill the kettle between the minimum and maximum
marks. Too little water will result in the kettle switching off
before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may
spill out of the spout when boiling. Ensure that the lid is firmly in
place before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the switch
and the indicator will light up. The kettle will start to boil
the water. The kettle will switch off automatically once the
water has boiled. If necessary, please wait 30 seconds before
re-boiling the water. You may shut off the power by lifting
switch up or directly lift the kettle from the power base at any
moment to stop boiling process.
5. Lift the kettle to pour the water.
NOTE: Operate carefully when pouring the water from your kettle as
boiling water may result in scald, besides, don’t open the lid while
the water in the kettle is hot.
6. The kettle will not re-boil until the switch is pressed again.
The kettle may be stored on the power base when not in use.
NOTE: Ensure power supply is turned off when kettle is not in use.