BEFORE FIRST USE
Check that all accessories are complete and the unit is not
damaged. Fill water into water tank to the
MAX level and brew water
for several times without coffee powder, then discard the water.
Clean and dry all detachable parts thoroughly according to the
section “
CLEANING AND MAINTENANCE”.
USING YOUR COFFEE MACHINE
1. Open the top lid and fill the water tank with drinking water. The
water level should not exceed
MAX level as indicated on the
water gauge.
2. Place the funnel into the funnel support, make sure it is
assembled correctly, otherwise the top lid cannot be closed.
Place permanent filter in the funnel.
3. Add coffee powder into permanent filter. Usually a cup of
coffee needs a level spoon of coffee powder, but you may adjust
according to personal taste. Close the top lid completely.
4. Insert the carafe with handle closed onto warming plate
horizontally.
5. Plug the power cord into the outlet. If you want to adjust the
coffee strength, you can press
STRENGTH button once, and
then its corresponding indicator will illuminate in orange and
the appliance will brew thick coffee. If you do not want to adjust
the coffee strength, just follow the following operation to brew
normal coffee.
6. Press ON/OFF button, its indicator illuminates in red, the LCD
display indicates “ 12:00”, and then the appliance begins to work.
Note: During brewing process, the buttons of PROGRAM, DELAY
BREW, HOUR and MINUTE are invalid.
7. The brewing process can be interrupted by pressing the ON/OFF
button at any time, the indicator will extinguish. The appliance
will continue brewing once the ON/OFF button is pressed again.
Note: You can take out the carafe, pour and serve at any time.
The appliance will stop dripping automatically. But the time
cannot exceed 30 seconds or dripping may recommence.
8. Remove the carafe to serve when the brewing is finished (about
one minute later after the coffee stops dripping out).
Note: The coffee you get will be less than the water you have
added, as some water is absorbed by ground coffee.
9. When the process is finished, if you do not want to serve
immediately, keep the coffee maker switched on and the coffee
will be kept warm in the warming plate. The appliance will shut
off automatically after 2 hours from the
ON/OFF button
being activated if it has not been manually disconnected at the
completion of brewing. For an optimum coffee taste, serve it just
after brewing.
10. Always turn the coffee maker off and disconnect the power
supply when not use.
Note: Take care when pouring as the temperature of coffee when
just finished is high.
SETTING THE CLOCK
To set the clock:
1. Make sure the coffee maker is plugged in. The clock will flash on
the display to indicate that the time has not been set yet.
2. Continually press the HOUR and then the MINUTE buttons until
you reach the current time. The
AM/PM indicator light will
appear for
PM and disappear for AM.
Note: The time cycle is 12 hours. You must set the clock if you want
to use the delay brew feature.
www.hadenusa.com
www.hadenusa.com
6
7
