13
Use
Operating Steps
In the following section the order in
which you should use the device is
described. Additionally, the individ-
ual steps will be explained in detail.
Read the complete manual before
use.
After connecting the device to the
power press the standby button (14)
to make it start rotating. Use the
buttons (2) and (3) to select a rota-
tion speed. Manufacturers often
provide recommendations for opti-
mal rotation speeds. However, it is
important that you never exceed the
maximum recommended rotation
speed.
You can now choose the rotation
direction using the button (4). The
most commonly used direction is
clockwise. Most milling instrument
(steel instruments with steel cutters)
are optimised for clockwise use.
The rotation direction is irrelevant
for diamond cutters and high-grade
corundum sanders in terms of effi-
ciency. Working anti-clockwise can
be beneficial if, for example, the
dust obscures your field of vision
when working clockwise.
Now switch on the suction with but-
ton (8). Using buttons (7) and (8)
you can adjust the intensity of the
suction. Frequently used rotation
speeds and suction power settings
can be saved. First select the de-
sired rotation speed and suction
power. Save these settings by
pressing the memory button m1 for
4 seconds. To use your custom
settings simply press m1. Other
values can be saved using memory
buttons m2 and m3.
After choosing rotation speed and
suction power you can start work-
ing. If you want to take a break or
finish the job, press the standby
button (14). The handpiece motor
and suction will turn off. The hand-
piece can now be placed in its
holder on the right of the unit. Alter-
natively, you can switch the device
to standby by pressing and holding
the button on the handpiece or by
pressing the button on the foot
switch.
We recommend to disconnect the
device from the mains power supply
if is not going to be used for a while.
This will save electricity. The mains
plug must also be removed when it
comes to retiring the device.
