13
Use
Operating Steps
In the following section the order in
which you should use the device is
described. Additionally, the individ-
ual steps will be explained in detail.
Read the complete manual before
use.
After connecting the device to the
power press the standby button (14)
to make it start rotating. Use the
buttons (2) and (3) to select a rota-
tion speed. Manufacturers often
provide recommendations for opti-
mal rotation speeds. However, it is
important that you never exceed the
maximum recommended rotation
speed.
You can now choose the rotation
direction using the button (4). The
most commonly used direction is
clockwise. Most milling instrument
(steel instruments with steel cutters)
are optimised for clockwise use.
The rotation direction is irrelevant
for diamond cutters and high-grade
corundum sanders in terms of effi-
ciency. Working anti-clockwise can
be beneficial if, for example, the
dust obscures your field of vision
when working clockwise.
Using buttons (7) and (8) you can
adjust the intensity of the suction.
Frequently used rotation speeds
and suction power settings can be
saved. First select the desired rota-
tion speed and suction power. Save
these settings by pressing the
memory button m1 for 4 seconds.
To use your custom settings simply
press m1. Other values can be
saved using memory buttons m2
and m3.
After choosing rotation speed and
suction power you can start work-
ing. If you want to take a break or
finish the job, press the standby
button (14). The handpiece motor
and suction will turn off. The hand-
piece can now be placed in its
holder on the right of the unit. Alter-
natively, you can switch the device
to standby by pressing and holding
the button on the handpiece or by
pressing the button on the foot
switch.
We recommend to disconnect the
device from the mains power supply
if is not going to be used for a while.
This will save electricity. The mains
plug must also be removed when it
comes to retiring the device.
