19
Usage
Memory Keys
Frequently used speed can be
saved. There are 3 memory spaces
available. First set the desired
speed. Save this by pressing one of
the three memory keys (15), (16) or
(17) for 4 seconds. The saved
speed is now directly available on
pressing the memory key. To recall
the stored speed quickly, briefly
press the corresponding memory
key (15), (16) or (17).
Only use burs/tools which are
permitted for speed level
saved under (16) to (17).
When the device is brought
out of standby mode, it will
run with the rotation speed
and suction power used last.
Take care to not start the mill
at an overly high rotation
speed. Select the required
rotation
speed
before
changing the milling tool.
Foot Switch
Operation of the foot switch
Only use the original hadewe foot
switch
(art. no. 0970)
to avoid any
damages. Insert the plug of the foot
switch into the socket with the
symbol
.
Function of foot switch
By holding down the foot switch, the
power can be switched ON/OFF.
While the spray is on, and you push
the switch once, the spray stream
will stop. If you push it a second
time, the handpiece will stop.
Pushing the switch, a third time,
both functions will start to work
again.
By briefly pressing the foot switch,
the handpiece and spray are
stopped (e.g. to change the tool/
bur). By pressing again briefly, the
handpiece and spray can be
reactivated.
When
the
display
is
switched off, you can turn it
on by keeping the foot
switch
pressed
(keep
pressed long).
