11
Before the use
Please read through the instructions
carefully before using the unit and
carefully note the safety advice.
Always keep this manual accessible
to any users of the drill.
Area of application
The control unit can be set up in a
cabinet, or can be used as a
portable unit (e.g. in a carry case). It
is suitable for the following scopes:
Footcare/Manicure:
Milling,
trimming and polishing
. (Attention:
Additional spray or suction might
have to be in operation during foot
care in your country).
Dental technique / -laboratory:
Milling-, trimming and polishing
work at plaster casts and models
(Do not use this unit for dentist
purposes, i.e. working directly on
the patient).
Industry: Grinding, milling and
polishing works.
Installation site / location
The installation of the workroom
must correspond to any regulations
according to your country laws. Set
up the control unit, so that the
ventilation slits are not covered or
blocked, and the exhaust air can
escape well.
The drill and the charging unit may
only be operated in confined
spaces. Temperature rising of the
housing is normal during operation.
Although the unit should never be
covered, nor be located near
heating devices or in direct sun
impact.
