- 11 -
Air cleaning function
1.
Unlock the lock latches by pulling them out as shown in
the figure and then remove the motor body by holding
it by the carrying handle.
2.
Place the water exhaust filter inside the tank.
3.
Add water up to the maximum water level (MAX. 2 lt.).
4.
Apply 4-5 drops of "Room perfume" to the filters on the
tank intermediate body and then place it on the tank
intermediate body.
5.
Hold the motor body by the carrying handle and place
it on the tank and lock the tank locking latches by
pressing right and left. While your appliance is running,
run the vacuum cleaner on one side without attaching
a hose to the suction nozzle.
NOTE:
The switch that activates the pump must remain
in the off position while performing the air purge
operation.
When this process is applied in a room for 25-30
minutes, your device will trap both bad odours and
bacteria floating in the air, and your environment will
become healthier.
NOTE:
When using the air cleaning function, the tank
and the intermediate body filters must be clean.
Summary of Contents for Aquaclean PRO
