English
5
Installation and connection
Choosing the site
•
Always place the refrigerator in a dry place with satisfactory ventilation. Never expose it to
direct sunlight or install it outdoors. Depending on its climate class (stated on the nameplate
inside the refrigerator compartment), the appliance can be used in different temperature
conditions:
Class
Ambient temperature
SN (Subnormal)
from +10 °C to +32 °C
N (Normal)
from +16 °C to +32 °C
ST (Subtropical)
from +16 °C to +38 °C
T (Tropical)
from +16 °C to +43 °C
•
Never place the refrigerator close to heat sources. If this is unavoidable, a suitable insulating
panel must be used to allow the appliance to function properly. Otherwise, place the
appliance at least 3 cm from electric or gas cookers and at least 30 cm from combustion or
radiation heating systems.
•
To allow proper cooling of the condenser, the refrigerator must not be placed too close to
the wall. If the refrigerator is installed underneath a wall cupboard, the distance between
the two must be at least 5 cm.
•
Take care not to scratch or damage the floor when installing the appliance on parquet or
linoleum. If necessary, when positioning slide the refrigerator over pieces of wood or a mat
to the point decided for connection to the electrical mains.
Positioning and levelling the appliance (Fig.2 & 3 & Section A)
Place the fridge on a stable and level floor. In case the floor is not perfectly level, use the two
adjustable feet on the front part of the fridge. To ensure major stability, easier movement and a
correct positioning of the product, two additional wheels are present at the rear. In any case we
recommend moving the fridge very carefully in order to avoid floor damage (especially in case
of wooden floor).
Electrical connection
Before switching the refrigerator on for the first time, leave it vertical for at least two hours.
Then connect the appliance's power supply plug to a mains socket with earth contact, installed
in accordance with electrical safety regulations. The rated voltage and frequency are stated on
the nameplate. The appliance must be connected to the electrical mains and earthed in
compliance with the relevant regulations and requirements. The appliance is able to withstand
short fluctuations in voltage of no more than 15% less or 10% more than the rated voltage stated
on the nameplate. If the power supply lead has to be replaced, this operation must only be
carried out by a qualified technician. The socket must be accessible after the appliance has been
placed.
Summary of Contents for North Pole 220
