English
9
Defrosting the freezer
The freezer compartment must be defrosted manually. When the thickness of frost or ice on the
shelves exceeds 2 cm, the freezer should be defrosted. A few hours before defrosting, use the
knob provided to set the thermostat on 7 to further lower the temperature of the frozen foods.
Then turn the knob to the 0 (stop) setting and disconnect the plug from the electrical mains.
Remove the frozen foods from the freezer compartment and protect them from thawing while
cleaning.
Cleaning the refrigerator
•
Before cleaning, disconnect the plug from the electrical mains. Clean the outside using only
water and a gentle liquid detergent or an ordinary detergent for washable surfaces (such as
a window-cleaning product). Never use products containing abrasives or substances which
may attack the lacquered or painted parts, acids or chemical solvents. Use a sponge or a soft
cloth.
•
Do not use steam cleaners to clean the inside;
•
Remove the shelves and accessories, taking care not to apply excessive force when
removing. Never wash removable plastic parts in the dishwasher; use only warm water and
washing-up liquid or water and vinegar. Take care not to wet the electrical lighting
components with water or detergents.
•
Clean the gaskets with warm water and then dry.
•
To allow the refrigerator to operate at full efficiency, periodically also clean the condenser
on the rear with a brush or a vacuum cleaner.
•
Also make a periodic check on the tray above the compressor and clean it if necessary.
Switching off the refrigerator
If the refrigerator is to be out of use for some time, turn the thermostat knob to 0 (stop). Then
empty the compartments, disconnect the appliance from the electrical mains, and once it has
defrosted dry any residual moisture which has collected. Leave the door ajar to prevent the
humidity and trapped air from creating unpleasant smells.
Replacing the refrigerator lamp (Section D) (*)
Before changing the lamp, make sure that the light has not stopped working simply because the
part inside the lamp socket has become loose. In all cases, whether you wish to check that the
socket is connected correctly or change the lamp, for safety reasons the plug must be removed
from the power socket.
1.
Unplug the appliance to make sure the appliance is disconnected from main power supply.
2.
Remove the screw of the lamp cover and pull the lamp cover out.
3.
Remove the old lamp and fit the new lamp according to the opposite direction then replace
the lamp cover and screw.
4.
Plug in the appliance and regulate the knob to right position.
(*) Note:
If your model is LED type, to replace the lamp, please contact qualified
technician.
Summary of Contents for North Pole 220
