Haes ESENTO MARINE ESEN-R-12MAR, Installation, Commissioning & Operating Manual

ESEN-RMAR Installation, Commissioning & Operating Manual

Approved Document Ref: UI-ESEN-RMAR-01 Issue 5.0

18

OPERATING

PANEL CONTROLS & INDICATIONS

8 Button Keypad For Controls

And Programming

Status Indicator LEDs

Activate Controls Key Switch

RESOUND

SILENCE

RESET

ENTER

1

2

3

4

General Disablement

Test Mode
Sounder Status

Aux Output Status
Power Supply Fault

System Fault

Delay Status

Access Level

Repeater Fault

On

Off

Supply Healthy
General Fire

General Fault

Activate

Controls

Zones in Fire

Zone Fault / Disabled / Test

Disable

Mode

Test

Mode

Mute

Buzzer

Test

Lamps

Zones In Fault, Zones Disabled or

Zones In Test Indicator LEDs

Zonal Fire Indicator LEDs

Activate Controls

In normal standby mode the keypad controls are inactive to protect from unauthorised operation. Controls 
can be activated by using the ‘Activate Controls’ key switch or by entering a four digit code using the 

keypad.

The use of a code entry to activate the controls is enabled by default but can be disabled in the Level 3 

engineering functions. 

To activate the controls using the key switch

Turn the key clockwise to the ‘On’ position. The ‘Access Level’ indicator LED will light and all buttons on 
the keypad will now be operational. To deactivate the controls, turn the key back to the ‘Off’ position and 
the ‘Access Level’ indicator LED will extinguish.

If the key switch is in the ‘On’ position the keypad will remain active.

NOTE :

 It is not possible to remove the key in the ‘On’ position.

To activate the controls using the keypad

Enter the four digit code using buttons 1 - 4. The factory default code is 1-2-3-4 but can be changed in 
the engineering functions. After entering the four digit code press the ‘ENTER’ button. The ‘Access Level’ 
indicator LED will light and all buttons on the keypad will now be operational.

After activation by code entry, controls will automatically deactivate again after 2 minutes and the panel 

will return to standby mode.

The test lamps and mute buzzer functions are operational without the need to activate controls.