4 (8)
This product shall only be installed and used as described in this manual.
The device is intended for domestic indoor use only.
When the towel warmer is installed with an electrical heater, we request you to read the assembly of said electrical heater before commencing installation.
This appliance can be used by children aged 8 years and above and people with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning safe use of the appliance and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not be performed by children without supervision.
The heated towel rail should be connected to a closed radiator system. Do not connect the heated towel rail to heating, ventilation and sanitation systems
(fresh-water systems) or underfl oor heating systems (low-temperature systems)
In order to avoid a hazard for very young children, this appliance should be installed so that the lowest heated rail is at least 600 mm above the fl oor.
Never drill holes into a wall without fi rst checking the dimensions of the towel warmer, as there may be minor measurement differences.
When connecting to a closed radiator system, the water pressure must not exceed 7 bar.
This towel warmer reach a temperature of about 60°C, which may feel hot to the touch.
The towel warmer is only to be used for drying fabrics washed in water.
Do not climbe on the towel warmer.
Since the heat is distributed in the towel warmer by natural circulation, the bottom two tubes maintain a lower temperature than the rest of the towel
warmer.
Use pure water in the towel warmer, or if there is a risk of freezing a mixturew of water and glycol. Use normal glycol for cars.
Heated towel rails that are installed in unheated rooms where there is a risk of frost damage occurring, e.g. in a holiday home, must be fi lled with liquid as
follows:
Degrees °C -4 -8 -15 -23 -35
Glycol % 15 20 30 40 50
Filling of the towel warmer should be compleated very slowly to avoid air pockets in the towel warmer. (se fi gure 6) Check the fl uid level in the towel
warmer after approx. one hour. The fl uid level shall be approx. 2cm from the top of the towel warmer at maximum temparature. Thereafter assemble the
plug and aeration.
GB
