Hafco Metalmaster BS-152, Operation Manual

10

OPERATION MANUAL

The full-load current rating is the amperage a machine draws when running at 100% of the out-

put power. Where machines have more than one motor, the full load current is the 

amperage drawn by the largest motor or a total of all the motors and electrical devices that 

might operate at one time during normal operations.

Full-Load Current Rating for these machine at 415V is 4.7 Amps

It should be noted that the full-load current is not the maximum amount of amps that the 

machine will draw.  If the machine is overloaded, it will draw additional amps beyond the 

full-load rating and if the machine is overloaded for a long period of time, damage, overheating, 

or fire may be caused to the motor and circuitry.

This is especially true if connected to an undersized circuit or a long extension lead. To reduce 

the risk of these hazards, avoid overloading the machine during operation and make

sure it is connected to a power supply circuit that meets the requirements.

3.2 FULL-LOAD CURRENT RATING

Place the machine near an existing power source. Make sure all power cords are protected from 

traffic, material handling, moisture, chemicals, or other hazards. Make sure there is access to a 

means of disconnecting the power source. The electrical circuit must meet the requirements for 

415V.  To minimize the risk of electrocution, fire, or equipment damage, these machines should 

be hard wired with installation work and electrical wiring done by a qualified electrician.

NOTE : The use of an extension cord is not recommended as it may decrease the life of electrical 

components on your machine. 

3.1 ELECTRICAL REQUIREMENTS

ELECTRICAL REQUIREMENTS

Nominal Voltage.........................................415V

Cycle.............................................................50 Hz

Phase................................................Three Phase

Power Supply Circuit...........................15 Amps

Full Load Current...............................  4.7 Amps

(Full load current rating is also on the specification plate on the motor.)

3. POWER SUPPLY