CHUCK & ARBOR
1.
Before any assembly, ensure the chuck
jaws are wound all the way up (inside
the chuck) to prevent them from
damage (Fig. 17).
2.
Tighten Philip's head screws of the
chuck guard to quill sha (Fig. 18).
3.
Fit the tapered arbor end into the
chuck by hand, using reasonable fore
(Fig. 19).
4.
The arbor can then be inserted into the
quill, twis ng the arbor as you insert,
aligning the tang into the slot. It should
fi
t in with li le resistance (Fig. 20).
11
Fig.17
Fig.19
Fig.20
5.
Once it is located a
fi
rm tap on the
underside of the chuck with a so
hammer is required to secure it. The
chuck & arbor are installed correctly if
they cannot be pulley out with hand
force (Fig. 21).
Fig.21
Fig.21
Fig.18
Fig.18
Page 12
Instructions Manual for PD-440 (D598)
19/11/2015
