INSTALLING STRAIGHT SHANK DRILL BITS
1.
Using the chuck key, loosen the jaws of
the chuck by rota ng in an
an -clockwise direc on (Fig. 26).
2.
Insert the drill bit into the chuck (Fig.
27).
3.
Whilst holding the drill bit in one hand
rotate the top collar of the chuck in a
clockwise direc on. Insert the chuck key
into 1 of the 3 rota ng holes and ghten
un l drill bit is secure (Fig. 28).
13
Fig.26
Fig.27
Fig.28
MORSE TAPER DRILL BITS
To use Morse taper bits, remove chuck and arbor.
1.
Turn arbor un l the tang aligns with the
slot in the quill (Fig. 29).
Fig.29
Page 14
Instructions Manual for PD-440 (D598)
19/11/2015
