FLOOR TYPE
To stop spindle (and bit) at a desired depth:
1.
Loosen depth stop lock knob by turning in an an -clockwise direc on (Fig.
33).
2.
Rotate depth scale to the desired depth, then ghten half wing bolt (Fig.
34).
To hold the spindle (and bit) at a desired depth:
1.
Loosen depth stop lock knob, turn feed
wheel handle to lowest point (Fig.35).
2.
Rotate depth scale to desired depth and
re- ghten depth stop lock knob. This will
hold assembly sta onery at desired
depth.
CHANING THE SPEED
BENCH TYPE
Before changing the speeds, ensure the machine is switched OFF, and
disconnected from the power supply.
1.
Open the pulley cover.
2.
Slacken o
ff
the belt tension locking knob, to relieve any tension on the drive
belt.
3.
Consult the chart inside the pulley cover, and posi on the belt on the
pulley's according to the spindle speed required.
4.
When the belt has been correctly posi oned, re-tension by levering the
motor away from the head.Lever the motor, with its bracket,away from the
head, so that tension is applied to the
belt. Tension is correct when the belt
de
fl
ects by approx. ½”at its centre,
when using reasonable thumb pressure.
Lock the motor in this posi on using
the locking knob.
Fig.34
Fig.36
Fig.33
15
Fig.35
Page 16
Instructions Manual for PD-440 (D598)
19/11/2015
