FLOOR TYPE
The speed of the drill press can be changed by adjus ng the belt on the pulley
system. See chart inside pulley cover for speed con
fi
gura ons.
1.
Release the belt tension locking knobs
located on either side of the main
housing (Fig.37).
16
2.
Once the tension is released, the belt
tension handle can be used to move the
motor pulley closer to the idler pulley
(Fig.38).
3.
The belt is removed by li ing it over the
lip of the pulley while rota ng the
pulley simultaneously (Fig.39).
4.
A er re-adjus ng the belts, use the belt
tension handle to move the motor pulley
further away from the idler pulley. When
the desired posi on is achieved use the
locking knobs to secure the pulleys in
place (Fig.40)
5.
Proper belt tension is achieved when
the measured de
fl
ec on (by pushing in
the centre of the belt) is approx. 5mm
(Fig. 41).
Fig.37
Fig.38
Fig.41
Fig.39
Fig.40
Page 17
Instructions Manual for PD-440 (D598)
19/11/2015
