Extra customer instructions
Stock Code
Page 2 of 2
Description
Date
W611
13/3/19
PT-254S Planner Thicknesser
With the outfeed table now set all the way up on its
adjustment and locked down. Carefully Drop down the infeed
table and wind its height adjustment hand wheel down a few
turns and then all the way up to it stop.
Now lock the infeed table lock lever.
With a steel straightedge, holding it down on the outfeed
table, slide the straightedge from the outfeed table over the
cutter head (not touching the blade) to the infeed table.
The edge of the rule should not foul on the opposite table if it
does then the infeed table needs adjusting down.
If the rule is above the infeed table, then the infeed table
needs adjusting up.
The adjusting and setting of the infeed table
is identical to the adjustment and setting of the outfeed table
as described in previous instructions above.
Except do not use a cutter head but the opposing table as a
setting device
Adjust the table stop until both tables are parallel with each
other and the steel rule will slide from one table to the other
without interference or rocking down to meet the other
table.
Please note.
as described in the current manual supplied the adjustment of the table for setting the knife states to unlock and adjust
the 2 positioning studs..
These do not get adjusted and are only for adjusting the table/s parallel to the spindle blades on resetting of the
spindle. Adjusting these screws should only be done by a trained technician as this can affect flatness and twist of the
tables if adjusted incorrectly. Future manuals will be revised.
