13
OPERATION MANUAL
5. OPERATION
This machine may perform many types of operations that are beyond the scope of this manual.
Many of these operations may be dangerous or deadly if performed incorrectly.
The instructions in this section are written with the understanding that the operator has the
necessary knowledge and skills to operate this machine. If at any time you are experiencing
difficulties performing any operation, stop using the machine!
If you are an inexperienced operator, we strongly recommend that you read books, trade
articles, or seek training from an experienced operator before performing any unfamiliar
operations.
Above all, your safety should come first!
5.1 OPERATION OVERVIEW
The overview below provides the novice machine operator with a basic understanding of how
the machine is used during the operation, so that the machine controls and parts discussed
later in this manual are easier to understand.
Due to its generic nature, this overview is NOT intended to be an instructional guide.
A typical operation, consists of the following:
1. Select the work piece to be cut, making sure that the material is suitable to be cut.
2. Raise the head and swivel the head lock into place. (Fig. 5.1) Place the work-piece in the vise
and close the vice jaws to with in 1mm or 2 mm
3. Lower the head and measure the length from the blade to be
cut and then tighten the vise.
4. Check the V-belt position on the pulleys to ensure that it is
the correct cutting speed for the work piece.
Refer to blade speed table on page 17
5. Check the band saw blade to make sure that the number of
teeth are suitable for the material.
Refer to blade selection chart on page 16
6. Make sure that there is no obstructions and the workpiece
and band saw are stable. Wear safety glasses and suitable
footwear.
7. Start the machine, and wait for blade to reach its full speed.
(Fig. 5.2)
8 . Slowly lower the head until blade makes contact with the
work piece, then release the head and allow the weight of
the head to continue to lower blade into the work piece until
the cut is finished. Stop the machine, raise the head, and
remove the workpiece
F
ig
. 5.2
F
ig
. 5.1
K
Å
H
eaD
L
ocK
