19
Slide left to disable child lock. To remove
Child Lock function from the machine, press
the On/Off and Start/Pause touch keys for 3
seconds at the same time again. At the end
of the 3 seconds, “CL0” will appear and the
child lock symbol (14.2) will turn off.
15-Start/Pause Key
This key allows you to start or pause the
program. Press and hold this key for 3
seconds to cancel.
7.1 Changing the Program
Follow the steps below to change the
program while the machine is running.
1.
Open the door and use the Program
Selection key (1) to select a new
program. If you open the door while the
machine is running, the time remaining
until the end will be shown on the
display (2).
2.
After closing the door, the newly
selected program will resume where the
previous program left off.
NOTE:
If you want to stop a washing
program before it ends, slightly open the
door of the machine first to prevent the
water from splashing.
7.2. Cancelling the Program
Follow the steps below to cancel the
program while the machine is running or in
standby.
1. Open the door of the machine; the last
selected program will be shown on the
display.
2. Press and hold the program key (1) for 3
seconds. At the end of the 3 seconds, the
display (2) will show '1'.
3. Once the door of the machine is closed,
water discharge will start and last 30
seconds. Buzzer will sound 5 times when
the program is cancelled.
NOTE:
Once the selected washing
cycle is completed and the door is opened,
a buzzer will sound and the display (2) will
show ‘0’.
7.3. Switching the Machine Off
When the selected washing program is
completed, the buzzer will sound 5 times.
You can use the On/Off key (9) to turn off
your machine.
NOTE:
Do not open the door until the
program finishes.
NOTE:
When the washing cycle ends,
leave the door ajar to speed up drying.
NOTE:
If you open the door of the
machine or if power gets cut while the
program is running, the program will
resume once the door has been closed or
the power has recovered.
NOTE:
If the power goes off or if you
open the door of the machine during drying,
the program will end. Your machine will
become ready for a new program selection.
Buzzer Sound Control
Follow the steps below to change the
volume of the warning sound:
1. Open the door and press the Extra Dry/
Energy Save (4) and Half Load (5) keys for
3 seconds.
2. When the sound setting is detected, a
long warning sound will be heard and the
machine will show the last level set, which
will be between “S0” and “S3”.
3. To lower the volume, press the Extra Dry/
Energy Save key (4). Press the Half Load
key (5) to turn the volume up.
4. Switch off the machine to save the
volume selected.
“S0” means all sounds are off. Factory
default is “S3”.
