21
8. CLEANING AND MAINTENANCE
8. CLEANING AND
MAINTENANCE
Cleaning your dishwasher is important to
maintain the machine’s service life
Make sure that the water softening setting
(If available) is done correctly and correct
amount of detergent is used to prevent
limescale accumulation. Refill the salt
compartment when the salt sensor light
comes on.
Oil and limescale may build up in your
Dishwasher over time. If this occurs:
•
Fill the detergent compartment but do not
load any dishes. Select a programme which
runs at high temperature and run the Dish-
washer empty. If this does not clean your
Dishwasher sufficiently, use a cleaning agent
designed for use with dishwashers.
•
To extend the life of your dishwasher,
clean the appliance regularly on each month
•
Wipe the door seals regularly with a damp
cloth to remove any accumulated residue or
foreign objects.
To remove and clean the filter combination,
turn it counter clockwise and remove it by
lifting it upwards (1).Pull the coarse filter out
of the micro filter (2).Then pull and remove
the metal filter (3).Rinse the filter with lots of
water until it is free of residue. Reassemble
the filters. Replace the filter insert, and rotate
it clockwise (4).
•
Never use your dishwasher without a
filter.
•
Incorrect fitting of the filter will reduce the
washing effectiveness.
•
Clean filters are necessary for proper
running of the machine.
8.1 Filters
8.2. Spray arms
Clean the filters and spray arms at least once
a week. If any food waste remains or foreign
objects on the coarse and fine filters, remove
them and clean them thoroughly with water.
a) Micro Filter b) Coarse Filter
c) Metal Filter
Make sure that the spray holes are not
clogged and that no food waste or foreign
object is stuck to the spray arms. If there is
any clogging,remove the spray arms and
clean them under water. To remove the
upper spray arm undo the nut holding it in
position by turning it clockwise and pulling
it downwards. Make sure that the nut is
properly tightened when refitting the upper
spray arm.