4
2. INSTALLATION
2. INSTALLATION
2.3 Water inlet hose
2.1 Machine positioning
2.2 Water connection
We recommend fitting a filter to your water
inlet supply in order to prevent damage to
your machine due to contamination (sand,
rust, etc.) from indoor plumbing. This will also
help prevent yellowing and deposit formation
after washing.
❗
NOTE:
printing on the water inlet hose!
If models are marked with 25
o
•, the water
temperature may be max. 25
o
•C (cold water).
For all other models:
Cold water preferred; hot water max
temperature 60
o
•C
An Aquastop water spout is available
with some models. Do not damage it or allow
it to become kinked or twisted.
When positioning the machine, place it in an
area where dishes can be easily loaded and
unloaded. Do not put the machine in an area
where the ambient temperature falls below
0•
o
C.
Read all warnings located on the packaging
before removing the packaging and position-
ing the machine.
Place the machine close to a water tap and
drain. Take into consideration that the con-
nections will not be altered once the machine
is in position.
Do not hold the machine by its door or panel.
Leave an adequate distance around the
machine to allow ease of movement when
cleaning.
Ensure the water inlet and outlet
hoses are not squeezed or trapped and that
the machine does not stand on the electrical
cable while positioning.Adjust the feet so the
machine is level and balanced. The machine
should be placed on flat ground otherwise it
will be unstable and the door of the machine
will not close properly.
‼
WARNING:
Use the new water
inlet hose supplied with your machine, do not
use an old machine’s hose.
‼
WARNING:
Connect the hose
directly to the water inlet tap. The pressure
supplied by the tap should be a minimum of
0.03 MPa and a maximum of 1 MPa. If the
pressure exceeds 1 MPa, a pressure relief
valve must be fitted between the connection.
‼
WARNING:
After the connections
are made, turn the tap on fully and check
for water leaks. Always turn off the water inlet
tap after a wash program has finished.
‼
WARNING:
Run water through
the new hose before connecting.
