Function
Working process
SWITCH
FUNCTION
(Power)
1. In the standby state, press the switch function button and the
machine will enter into power in the 1st stage. You can adjust the
stages whatever the higher one or the lower one easily, as well as
slide or press the stage one by one. The maximum can be adjusted
to 9 stage, and the minimum is adjusted to 1st stage. The power
range is 600W, 800W, 1000W, 1200W, 1400W, 1600W, 1800W,
1900W, 2000W.
2. Press the timer button during work to set the time, the setting
range is:"01-99" minutes. The power can be adjusted in the
countdown state of the timing
3. The right infrared hob default setting is enter into the 1
st
stage, with
double rings heating, it shows 1 or = alternately.
SWITCH
FUNCTION
(Temperature)
1. Press the switch function button to switch to show
temperature,the default setting is 60
℃
.For the left induction hob
range is 60
℃
, 80
℃
, 100
℃
, 120
℃
, 140
℃
, 160
℃
, 180
℃
, 200
℃
,
220
℃
, the right infrared hob range is 65
℃
, 150
℃
, 250
℃
, 300
℃
,
350
℃
, 400
℃
, 450
℃
, 500
℃
, 570
℃
.
2. Showing temperature CANNOT use booster function.
3.Press the timer button during work to set the time, the setting
range is: "01-99" minutes. The power can be adjusted in the
countdown state of the timing.
Timer
Press the timing button when you need a timing setting during the
appliance working. The 4-digit digital displaying 00 can be adjusted
by 1 stage down and 9 stage up to adjust the time. Short press and
long press timer + increase or decrease 1 minute. After the time is
set, it will enter the timer countdown Status, the display shows the
timing furnace head countdown time and the gear alternately. The
timing range is 01-99 minutes.
Lock
1. Press and hold the lock button for 2 seconds while the power is
on, the machine will be locked, and the four-digit digital screen will
display “LO”. Pressing other keys is invalid at this time.
2. Press and hold the lock button for 2 seconds during work to lock
the working state of the machine. The middle two digits of the four-
digit digital tube will display “LO”. Pressing other keys after locking
is invalid (except the switch key)
3. In the locked state, press and hold the lock button for 2 seconds
to exit the lock.
4. After locking, if you don't press the button, the button will not
display “LO”, if you press the button, it will display “LO”.
FUNCTION INSTRUCTION
10
