Mounting instructions
28
engl.
The electronic board can be destroyed if inappropriate tools are
used!
Õ
Connect the cables of the devices to be connected by means of the
connecting tool supplied only.
1
2
1 Connecting
tool
2 Contact
terminal
11. Open the contact terminals using the connecting tool.
12. Put the cables into the contact holes.
13. Remove the connecting tool.
14. Put the reader head cable into the pin contact strip.
15. Put the data line (cascading cable) into the female Western plug.
16. Use the plastic screws supplied to fix the cover on the casing.
17. If the control electronics module is flush mounted: fit the inspection
flap.