Mounting instructions
engl.
29
Setting into Operation
Allocate programming and deletion key sticks
Programming and deletion key sticks are allocated in stand alone mode
during first commissioning.
This can be implemented only after supply voltage is fed to the CL
terminal.
The locking mode of the CL terminal is pre-set, such that the
connected CL terminals are unlocked for approx. 5 seconds when an
authorized electronic key is placed in front of them. Other locking
modes can be programmed, too (e. g. alternating unlocking/locking
when placing an authorized key in front of them). The locking mode can
be modified via special transponder only before programming and
deletion keys are allocated. Please contact your Dialock sales office for
this purpose.
Prevent misuse by unauthorized persons!
Õ
Keep programming and deletion keys safe, as they might be used to
allocate or withdraw locking authorisations to or from an electronic
key.
1. Keep the green programming and the red deletion key sticks at
hand.
2. If voltage is fed to the CL terminal already, disconnect the voltage
supply.
3. Connect it to the voltage supply again.
The green LED flashes for a few seconds.
4. Place the green programming key stick in front of the reading
module while the green LED flashes.
The red LED starts flashing for a short time to confirm that the
learning procedure has been successful.
5. Place the red deletion key stick in front of the reader module, while
the red LED flashes.
The red LED is illuminated.
If errors have occurred during the allocation procedure, proceed as
follows:
Õ
Disconnect the voltage supply feed and connect it again.
