29
Mounting and Brief Operating Instructions
E
n
g
lis
h
Dialock Cylinder DC - Status: 09.2003 - 732.29.140
Replacement of batteries
When the batteries no longer have sufficient power, the red and green
LEDs flash alternately three times after switching on.
Important:
The Dialock DC Cylinder will only function correctly when exhausted
batteries are replaced immediately.
1. Unscrew the three grub screws (7) and pull off the inner knob (10).
2. Remove the contact bridge.
3. Insert the new batteries.
Ensure they are inserted the right way
round!
4. Push the contact bridge (9) back into position.
5. Place the inner knob (10) in position and using the Allen key, screw the
three grub screws (7) hand tight.
6. Function test: Press the white button on the panel. The red LED must
light up briefly.
