2
® Copyright 2010 by Schulte-Schlagbaum AG
Nevigeser Straße 100-110
D-42553 Velbert
Phone: +49 2051 2086-0
http:/www.sag-schlagbaum.com
Document number: 6-703-2 34R1.0
• This manual replaces all previous versions.
• The details in this manual are subject to change without prior notification.
• The compilation of the information in this manual is carried out to the best of our knowledge.
Schulte-Schlagbaum AG does not assume any liability for the correctness and completeness of the
details in this manual. In particular, Schulte-Schlagbaum AG cannot be held liable for consequential
damages on account of faulty or incomplete details.
• Relaying and duplication of this document and the exploitation and communication of its contents
are not permitted unless expressly allowed. Violations shall obligate to provide compensation for
damages. All rights reserved in the event of patent grant or registration of a utility model or design.
Means of depiction
The following means of depiction are used in this manual:
Notice
Please observe this important information.
Handling instructions
These mark a work step during user input.
SAFE-O-TRONIC®
is a registered trademark of Schulte-Schlagbaum AG.
Safety and warning notes
Please read before initial operation
.
• This manual describes the initial operation and operation of a SAFE-O-TRONIC® LS 100.
• The equipment must only be used for the purpose intended by the manufacturer.
• Please keep the instruction manual in an easily accessible place.
• Unauthorized amendments and the use of spare parts and auxiliary devices that are not sold or
recommended by the manufacturer of the equipment can cause fires, electric shocks and injuries.
The manufacturer will not be liable.
• Repair work must only be carried out by the manufacturer.
• The warranty provisions of the manufacturer as amended on the date of purchase shall apply to the
equipment. Liability will not be assumed for unsuitable and automatic compilation of parameters for a
device or unsuitable application of a device.
• The operating company shall bear the responsibility that the device is installed and connected
according to recognized technical rules in the country of installation as well as other valid regulations.
Notes on this manual
