Manual SOUNDSYSTEM 420R
applicable for
822.65.004
Version (Technical and optical modifications reserved)
03.08.2015
Seite 9 von 13
(
button 1-9
).
Automatic assignment of the channel positions
The radio channels 1-9 can be assigned automatically
- First press the "
MEM
" button and then the "
SCAN
" button
Note:
The complete scan may take a few minutes.
Manual fine adjustment
The device allows a manual channel fine adjustment
- Press the "
MEM
" button and then "
0
"
- Change the frequency by pressing the "
/ -
"
- Save the settings with numeric key "
1-9
"
Note:
After about 2 seconds without key operation the fine tuning is completed. The keys "
/ -
" then
revert to their normal functions.
Activating „Power-Off / Remind Settings“ (PORS)
The tuner can be programmed so that it is back in operation again (in the case of power failures or when
it is switched “ON / OFF” with a light switch) with the latest settings when power is re-applied.
This must be activated with the initial start when using the PORS-function:
- Press the „
FREQ
“ button
- Then press the button sequence „
2
“ „
2
“ „
2
“ „
1
“
The command is acknowledged by a double „
beep
”.
Deactivating „PORS“
- Press the „
FREQ
“ button
- Then press the button sequence „
2
“ „
2
“ „
2
“ „
0
“
The command is acknowledged by a double „
beep
”.
Note:
After disconnecting power supply in this mode the SOUNDSYSTEM 420R starts again with the last
tuner settings (not in Bluetooth pairing mode!).
Actvating „PowerOff / Remind Settings“ / back to Bluetooth pairing mode
The tuner can be programmed so that it is back in Bluetooth pairing mode again (in the case of power
failures or when it is switched “ON / OFF” with a light switch) with the latest settings when power is re-
applied. This must be activated with the initial start when using the PORS-function:
- Press the„
FREQ
“ button
- Then press the button sequence „
3
“ „
3
“ „
3
“ „
1
“
The command is acknowledged by a double „
beep
”.
Deactvating „PowerOff / Remind Settings“ / back to Bluetooth pairing mode
- Press the „
FREQ
“ button
- Then press the button sequence „
3
“ „
3
“ „
3
“ „
0
“
The command is acknowledged by a double „
beep
”.
General features in Tuner operation
Saving configuration settings
The station selection and the volume setting are saved automatically every 10 seconds.
