4. INSTALL STRIKE
5. INSTALL THUMBTURN ASSEMBLY AND BLANK PLATE
a.
b.
c.
SIDE VIEW ASSEMBLED
RELEASE
SWITCH
2-3/8"
BACKSET
2-3/4"
BACKSET
LATCH
CRANK
THUMBTURN
TORQUE BLADE
LATCH
PLATE
LATCH MOUNTING PLATE
SIDE VIEW ASSEMBLED
RELEASE
SWITCH
2-3/8"
BACKSET
2-3/4"
BACKSET
LATCH MOUNTING PLATE
To set latch to 2-3/8" setting, pull up Release Switch on both sides.
While holding Release Switch up, slide crosshairs to the 2-3/8" marked hole.
Close door. Locate strike in jamb
and center line of strike. Open
door and extend line to door stop.
Measure half of door thickness
plus 1/8" from door stop. Vertically
mark centerline for strike.
Drill (2) 1"(25.4 mm) holes 1-1/4" (31.7 mm)
deep in door jamb, 5/16" (8 mm) above and
5/16’" (8 mm) below horizontal center line.
CAUTION:
Hole must be drilled a full 1-1/4" (31.7 mm)
deep to ensure proper functioning.
Match screw holes on strike with
vertical centerlines on jamb. Mark
outline of strike and chisel 1/4"
(6.4mm) deep for flush fit of dust
box, wood frame reinforcer, and
strike. Place dust box and wood
frame reinforcer into mortised area
and tighten to the frame using 3"
wood screws. Insert the strike and
tighten to the frame with #8 screws.
Insert torque blade horizontally into latch crank until thumb turn assembly is
flush with door face. Place the blank mounting plate on the outside of the door
and line up the threaded posts with the holes of the thumbturn assembly. Insert
the screws thru the holes of the thumbturn assembly and latch body. Tighten
the screws to the threaded posts of the blank mounting plate. Tighten the assembly
so the complete assembly is tight to the door.
6. BACKSET ADJUSTMENT
REV.
DESCRIPTION
ECO NO.
DATE
WEIGHT: 0.79
3200 SERIES DEADBOLT
-
Material <not specified>
-
-
-
-
-
PROPRIETARY & CONFIDENTIAL
THE INFORMATION CONTAINED
IN THIS DRAWING IS THE SOLE
PROPERTY OF HAGER
COMPANIES. ANY REPRODUCTION
INPART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF
HAGER COMPANIES IS PROHIBITED.
SHEET 1 OF 1
Q.A.
ENG. APPR.
DRAWN
TOLERANCES:
FRACTIONAL: 0.015"
ANGULAR: MACH: 1 BEND: 1
TWO PLACE DECIMAL: 0.01"
THREE PLACE DECIMAL: 0.004"
DO NOT SCALE DRAWING
FINISH
MATERIAL
REV.
A
DWG. NO.
SIZE
SCALE:1:4
HAGER RESERVES
THE RIGHT TO
MAKE DESIGN
CHANGES
WITHOUT NOTICE.
CALL HAGER
ENGINEERING AT
1-800-325-9995
FOR THE LATEST
REVISION DATE
OF TEMPLATE.
-
LATCH
CRANK
TORQUE BLADE
THUMBTURN
ASSEMBLY
BLANK MOUNTING
PLATE
