I-LS02111
www.hagerco.com
13
Rev 1, 5/16
If the setting is successful, then the buzzer will beep once with a green light. If
the setting fails, then the buzzer will beep three times with a blinking red light.
The setting sequence will be exited if the idle time is more than 20 seconds, or
[#] is pressed to exit immediately.
LLL: User ID; Range 001-500; Type: Manager
Manager Access Codes can be continuously deleted with this function as shown
above in 3.1.13.4. Delete User Access Codes until finished by hitting [#].
3.1.13.6.
Delete Service User Access Codes
Use the following code to delete service user access codes:
[
＊
] [Master or Manager code] [
＊
] [22] [
＊
] [LLL] [
＊
]
If the setting is successful, then the buzzer will beep once with a green light. If
the setting fails, then the buzzer will beep three times with a blinking red light.
The setting sequence will be exited if the idle time is more than 20 seconds, or
[#] is pressed to exit immediately.
LLL: User ID; Range 001-500; Type: Service User
Service User Access Codes can be continuously deleted with this function as shown
above in 3.1.13.4. Delete User Access Codes until finished by hitting [#].
3.1.13.7.
Delete All Access Codes
Use the following code to delete all access codes:
[
＊
] [Master or Manager code] [
＊
] [23] [
＊
] [29] [
＊
]
If the setting is successful, then the buzzer will beep once with a green light. If
the setting fails, then the buzzer will beep three times with a blinking red light.
The setting sequence will be exited if the idle time is more than 20 seconds, or
[#] is pressed to exit immediately.
3.1.13.8.
Activate User Access Codes
If a user code has been deactivated for a period of time, such as during a vacation,
it can be reactivated using this function. User codes that will be needed again in the
future should be deactivated rather than deleted.
Use the following code to activate user access codes that have been deactivated:
[
＊
] [Master or Manager code] [
＊
] [30] [
＊
] [LLL] [
＊
]
If the setting is successful, then the buzzer will beep once with a green light. If
the setting fails, then the buzzer will beep three times with a blinking red light.
