I-LS02111
www.hagerco.com
8
Rev 1, 5/16
3.1.8.
Setting Tamper Alarm Duration
Use the code below to set the duration of the Tamper Alarm in seconds:
[
＊
] [Master or Manager code] [
＊
] [00] [
＊
] [03] [
＊
] [SS] [
＊
]
If the setting is successful, then the buzzer will beep once with a green light. If the
setting fails, then the buzzer will beep three times with a blinking red light.
The setting sequence will be exited if the idle time is more than 20 seconds, or [#] is
pressed to exit immediately.
SS:
Continuous Alarm Time; Range 10-99 seconds; Default is 30 seconds
3.1.9.
Setting Wrong Entry Attempt Limit
This code sets the limit to the number of code entry attempts before the lock goes into
suspend mode. Use the code below to set the Entry Attempt Limit:
[
＊
] [Master or Manager code] [
＊
] [00] [
＊
] [08] [
＊
] [TT] [
＊
]
If the setting is successful, then the buzzer will beep once with a green light. If the
setting fails, then the buzzer will beep three times with a blinking red light.
The setting sequence will be exited if the idle time is more than 20 seconds, or [#] is
pressed to exit immediately.
TT:
Wrong Entry Attempt Limit; Range 00-10; Default is 03
TT=00 deactivates the suspend function
3.1.10.
Setting Suspend Duration
This code sets the time duration (in minutes) for the Suspend Keypad due to
consecutive wrong entry attempts. Use the code below to set the suspend duration:
[
＊
] [Master or Manager code] [
＊
] [00] [
＊
] [04] [
＊
] [MM] [
＊
]
If the setting is successful, then the buzzer will beep once with a green light. If the
setting fails, then the buzzer will beep three times with a blinking red light.
The setting sequence will be exited if the idle time is more than 20 seconds, or [#] is
pressed to exit immediately.
MM: Suspend Duration in minutes; Range 01-60 minutes; Default is 01 minute
NOTE:
You cannot make any operations on the lock during the alarm period
You can stop the alarm situation by turning off the POWER SWITCH or
removing the batteries.
