3500 Series ANSI Grade 2 Lever Set
Installation Instructions
Meets ANSI 156.2
I-LS00768
REV 2
Page 2 of 2
5. REMOVE INSIDE TRIM
Use catch release tool to depress lever catch
visible under hole of inside lever shank and slide
off inside lever, rose, rose liner, and mounting
plate.
6. ADJUST DOOR THICKNESS
A. Outside mounting plate is
pre-set for 1-3/4” door
thickness. To fit different door
thicknesses, remove outside
lever, rose, and rose liner. Now
adjust the outside mounting
plate by rotating plate until tip of
catch release tool lines up with
desired door thickness indicated
on lock body assembly.
7. INSTALL OUTSIDE LEVER ASSEMBLY
8. INSTALL INSIDE MOUNTING PLATE AND ROSE LINER
A. Install mounting plate tight
to door face and tighten screws
securely to the lockbody using
interior mounting holes.
Install outside lever assembly on the door. Make
sure tail of latch engages with retractor correctly as
illustrated.
B. Install removable
screw post into slots
on outside mounting
plate. Install rose liner
and align rose liner
arrow in the direction
of the lock stile. Install
outside rose and lever
onto lock body
assembly.
B. Install inside rose liner and align rose
liner arrow in the direction of the lock stile.
Tighten rose liner to the thru posts using
mounting screws.
9. INSTALL INSIDE ROSE AND LEVER
10. REPLACE CYLINDER
(SKIP THIS STEP IF INSTALLING 3510 OR 3540)
A. Align indent on inside rose
with groove on inside rose liner.
Press inside rose onto inside rose
liner and rotate clockwise to fully
seat inside rose.
B. Push lever all the way in
until it clicks into catch hole.
A. Turn key clockwise 1/4 turn.
B. Using catch release tool,
press the lever catch and pull
the lever off.
LOCK BODY ASSEMBLY
LATCH
OUTSIDE LEVER
ASSEMBLY
INSIDE MOUNTING
PLATE
INSIDE ROSE LINER
INSIDE ROSE
INSIDE LEVER
CATCH RELEASE TOOL
OUTSIDE ROSE
REMOVABLE SCREW POST
OUTSIDE
MOUNTING
PLATE
ROSE LINER ARROW
CATCH RELEASE
LOCATION
CATCH RELEASE TOOL
OUTSIDE
MOUNTING PLATE
OUTSIDE LEVER ASSEMBLY
INSIDE MOUNTING PLATE
MOUNTING SCREWS
ROSE LINER
ARROW
INSIDE ROSE LINER
MOUNTING SCREWS
INSIDE MOUNTING PLATE
GROOVE INDENT
INSIDE
ROSE
INSIDE ROSE LINER
INSIDE LEVER
INSIDE ROSE
LEVER CATCH
