4600 Series Narrow Stile Trim
Installation Instructions
I-ED01164
Rev 3, Rev Date: 8/4/2017
27390048
Page 4 of 5
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
3.
INSTALL NIGHT LATCH RIM CYLINDER (for NL trim only)
A.
Replace standard length tailpiece with extra-long tailpiece (2-3/8”).
B.
Install rim cylinder into collar and escutcheon trim.
C.
Install cylinder mounting bracket from back side of escutcheon trim as shown below.
D.
Adjust break-off screws to eliminate excess length and secure rim cylinder.
E.
Insert key and rotate. Observe the back of the trim and verify that the tailpiece rotates.
4.
DRILL MOUNTING HOLES FOR ESCUTCHEON TRIM
A.
Mark horizontal centerline by matching it to exit device centerline,
which can be found on the push side of the door.
B.
Mark vertical centerline by matching it to exit device centerline,
which can be found on the push side of the door. Refer to Applications
section on page 2 to determine the location of the vertical centerline.
C.
Apply template to door using centerlines.
D.
Mark and drill holes as shown below.
i.
Note that the mounting holes are the same for all functions but
the tailpiece clearance hole is different depending on function.
Note: Available templates include T-ED01194 – 4600 Trim Template (BE,
CE,DT) and T-ED01195 – 46NL Trim Template
#12-24 Break-off screws
Cylinder Mounting Bracket
46NL
Night Latch
5/8” Collar
RIM Cylinder
Part No. 3901
& Extra Long Tailpiece
Part # 2-639-7058
(Both Sold Separately)
Door Stile
(Pull Side)
Frame
Note B
Note C
N
ot
e
A
Note A
Notes:
A.
Trim centerline corresponds to exit device centerline.
B.
Trim mounting clearance holes (2 places):
i.
Drill ø 1/2” [13] holes on pull side.
ii.
Drill ø 5/16” [8] holes on push side.
C.
Trim tailpiece clearance hole:
i.
For CE, NK and BE functions:
1.
Drill ø 3/4” [19] hole on pull side.
2.
Drill ø 1/2” [13] hole on pull side.
ii.
For NL function, drill ø 1/2” [13] thru hole.
iii.
Not required for DT function.
