4600 Series Narrow Stile Trim
Installation Instructions
I-ED01164
Rev 3, Rev Date: 8/4/2017
27390048
Page 5 of 5
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
5.
ADJUST TELESCOPING ACTUATING SHAFT (for BE, CE and NK trim only)
A.
The telescoping actuating shaft is preset at the factory for a 1-3/4” thick door. For thicker door applications
follow these steps:
i.
Remove the small screw on the side of the actuating shaft and keep it handy for the next step.
ii.
Use the chart below to choose the appropriate setting for your door application. For other door/shim
kit thicknesses, use the closest larger size.
iii.
Slide the center shaft out until it lines up properly with the setting you chose in the last step.
iv.
Replace the screw and secure.
v.
Check for proper engagement with the exit device in the next step.
INSTALL ESCUTCHEON TRIM
A.
Insert trim mounting
posts and actuating shaft
through door.
B.
Mate trim actuating
shaft with cam on
back of exit device.
C.
Secure from push
side of door with
provided ¼”-20
machine screws.
D.
Test installation by
rotating lever
handle or key to
verify trim functions
properly.
4600 Narrow Stile
Exit Device
Adjust Shaft Length
Telescoping Actuating Shaft
Remove Screw
Preset Door Thickness Positions
For Telescoping Actuating Shaft
3”
2-
1/
2”
2”
2-
1/
4”
1-
3/
4”
(Fact
ory
pre
set
46CE Cylinder Escutcheon
Door Stile
¼”-20 Mounting Screws
Replace Screw