Step 4. Installation of the Lock (CONT
.
)
Ensure spindle hub is at center of trim bore. Use spindle or screwdriver to
test bolt retraction; if not smooth, troubleshoot as follows:
- Check 2-1/8" trim bore dimensions
- Ensure hole is free of debris
- Make sure 1" lock bore is perpendicular to trim bore
- Check lock by removing it from bore and throwing
Fasten the
two
wood screws inside the trim
bore hole
through lock body and into wood
stud.
Insert trim into spindle
hole. Use thumb
turn to
test
lock bolt movement.
Fasten trim screws until trim is tight to
jamb surface. NOTE: Do not over tighten.
Step 5. Installation of Face Fixing Trim
5.1) Cut spindle and and screw to accommodate wall side backset.
Edge to Lock Center B
1”
1-1/4”
1-1/2”
1-3/4”
2”
2-1/4”
2-1/2”
Spindle Length L
1-1/4"
1-1/2"
1-3/4"
2"
2-1/4"
2-1/2"
2-3/4"
Screw Length H
13/16"
1-1/16"
1-5/16"
1-9/16"
1-13/16"
2-1/16"
2-5/16"
Step 6. Prep and Install Dust Proof Strike with Emergency Release On Barn Door
Move the Barn Door to the
Closed position; throw the lock
bolt to mark the exact strike
center position. Make sure this
location is min
imum
1” to the
edge of the door.
With the
pilot hole as a guide, use a 1/4" bit to drill a
hole from
the
outside to connect with the strike bore
hole
.
Door
Outside
Face
Note: Standard Barn Door to wall
clearance is approximately 3/8" to 1/2".
Install additional spacer as needed behind
the strike faceplate if the door to wall
clearance is over 1/2". Additional spacers
can support maximum clearance of 3/4"
between
d
oor and wall.
Cut break-away
screw to
appropriate
door thickness.
DO NOT OVER
TIGHTEN
Install break
-
away screw and
tighten with
A
llen wrench.
DO NOT OVER TIGHTEN.
Screw on
decorative cap
by
hand.
Install the 1" dust-proof strike with the 1/4"
release screws on the outside.
Use release key (provided with lock
set) to push through center hole on
release to push lock bolt back and
unlock door.
4.4)
the bolt. Adjust wall prep as needed
4.5)
5.2)
5.3)
6.1)
6.2)
6.3)
6.4)
6.5)
6.6)
6.7)
Using the strike center position as a
guide, drill a pilot hole through the
door with a 1/8" bit from strike side.
With the pilot hole as guide, use a
1" diameter hole saw to drill a 1-1/4"
deep hole.
DO NOT drill through the door
!
