Technical data
Technical changes reserved
11
Materials
-
Door and frame:
-
Steel, 1 mm thick
-
Powder-coated with epoxy polyester paint then baked
-
Metal plate wall cabinet made of hot-dip galvanised steel, 1 mm thick
-
Material for insulated parts:
-
Polystyrene (PS): Covers, head/foot sections, rear panel, extrusion profile
-
Polycarbonate/acrylonitrile styrene acrylate (PC/ASA): Corner sections,
multimedia panel
-
Polycarbonate (PC): Multimedia door inserts
-
Material for univers FW support towers:
-
Polyamide 6 (PA6): Bottom parts, double towers
-
Polycarbonate (PC): Top parts
-
Vertical uprights and DIN rails made of hot-dip galvanised steel, 1 mm thick
-
Multimedia steel supports (patch panels) made of hot-dip galvanised steel,
1.5 mm thick
-
Multimedia perforated plates made of hot-dip galvanised steel, 1 mm thick
Plastic parts in direct contact with the area behind the wall (e.g. corner sections
and head/foot parts) pass a glow-wire test at 850 °C. Therefore, the enclosure is
suitable for hollow wall applications.
In sum: Standards and regulations
-
Tested according to EN 61439-1/-3 (VDE 0660-600-1/-3)
-
Dimensions according to DIN 43780
-
Protection type IP30 according to VDE 0470 Part 1 (DIN EN 60529)
-
Protection type IP3X with open door or without door
-
Air clearance and creepage distances according to VDE 0110, part 1
and 2/1.89
-
Rated insulation voltage: AC 400 V
-
Overvoltage category III
-
Degree of pollution 3
-
Insulation class I
-
Suitable for hollow wall use
