univers FW internal fitting system
Technical changes reserved
73
Mounting the UM00M0 plastic mounting plate on the back of vertical uprights
Mounting plate attached to the back of the vertical uprights (top of picture)
and to the front of the vertical uprights (bottom of picture)
If the mounting plate is installed in the head/foot section area (area at < 113 mm
from the top/bottom corner of the support frame), the mounting plate must be
turned 180° to click the support frame into place.
Mounting the plastic plate < 113 mm above the top corner of the support frame: the plate
must be turned 180°
Standard univers tapping screws 4.2 x 9.5 mm (e.g. UZ100) can also be screwed
into the mounting plate provided that the specified torque (1.2 Nm) is not
exceeded.
