univers FW internal fitting system
Technical changes reserved
77
A special cover can be mounted on top. Before doing so, 2 tower overparts
(UZ02A1) must be inserted. The cover has 2 claws at the front which engage
under the support.
Installing the patch panel cover with 2 tower overparts
The cover can also be screwed onto the plate support with the aid of the visible
pre-punch in the central area.
The cover can be ordered with product code UM00S2 or with the UM00S1 set.
With both of these items, the tower overparts are already included.
The existing Volta FZ12MM and FZ12MMO patch panel supports can also be
neatly covered with the new cover. To do so, the black plastic patch panel holder
must be screwed into the 87.5 mm position.
Mounting the cover for the Volta patch panel support
The Volta triple socket can be directly installed in the lower area. It must be
screwed in through the elongated holes at the side of the socket housing into the
first 3.2 mm diameter hole (at 47.5 mm from the lower edge of the vertical
uprights).
