Accessories for interior fittings
Technical changes reserved
93
7.2
General accessories in detail
7.2.1
Hollow wall anchor VZ405N
For hollow wall applications, the enclosure can be quickly attached using the
VZ405N fastening set (as used with Volta and New VegaD). The enclosure body
is pre-equipped for mounting the hollow wall anchor. The installation is similar to
the installation with Volta or New VegaD.
Suitable wall thickness: 6–26 mm
Hollow wall anchor VZ405N
Bracing the enclosure weight with supports
As the hollow wall anchors only engage into the wall laterally, part of the
enclosure’s weight must be supported from below.
-
Support the base of the enclosure to take up the weight of the wired
enclosure.
-
If the enclosure is very heavy, Hager recommends mounting a transverse
batten beneath it. To do so, see also installation manual 6LE005468A
supplied with the enclosure.
For a hollow wall installation, support the weight of the enclosure from below. If the
enclosure is very heavy, mount a transverse batten beneath the enclosure to support it.
You can also secure the wall cabinet
initially by screwing it through the
elongated holes on the side walls of
the body.
