EQ34 GRADE 1 CYLINDRICAL LOCK
INSTALLATION INSTRUCTIONS
I
-
LS02688
Rev 1, Rev Date: 01/12/2023
[27390107]
Page
2
of
7
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325
-
9995 www.hagerco.com
1
Safety Information
Carefully read the instructions before installing and using this lock.
WARNING:
If the door needs to be drilled, be familiar with how to safely use your tools, and understand all the door preparation steps
before proceeding.
FINISH & CARE NOTES:
Either remove the locks or do not install them prior to painting your door to protect the finish. Periodically clean
the locks with mild soap and a soft cloth. Do not use abrasives or harsh chemicals when cleaning or using the lock.
Required Tools
2
T10
PH2
PH3
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
3
Prepare Door & Frame / Install Latch & Strike
Skip the prep steps if the door has already been prepared. Just install the latch
and strike as shown below.
1
NOTE
: Drill from both sides to avoid splintering the finished surface of wood doors
Distance from
finished floor
2
10
Mark the Lever Centerline on the door face and edge at desired distance from the finished floor. Align the template and
mark the door, drill the holes. Insert latch, trace around face plate and chisel out a mortise pocket. Use a Ø1/8
” [3.2
mm]
pilot holes for 2 EE screws. Install
#10
latch using two #8 screws,
EE
.
EE
Drill x2
Chisel out
Mark Jamb for strike as shown below. Drill two Ø1
” [25.4
mm] holes
3/4” [19
mm] deep in the jamb
15/16” [8
mm] above
and below the horizontal center line and then chisel out. NOTE: To ensure proper lockset function, the hole in the jamb
must be drilled a full
3/4” [19
mm] deep.
Mark jamb for strike and chisel out to a depth of
3/32” [2.4
mm] or until flush. Drill 2 pilot holes for #12 strike screws.
Install
#1
Strike with two #12 screws,
DD
.
2X PILOT
HOLES
Ø
3/16”
DD
1