EQ34 GRADE 1 CYLINDRICAL LOCK
INSTALLATION INSTRUCTIONS
I
-
LS02688
Rev 1, Rev Date: 01/12/2023
[27390107]
Page
5
of
7
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325
-
9995 www.hagerco.com
5
•
Install Hex Standoff
HH
.
•
Install Main Gasket
#20
onto the backplate centered on
the escutcheon.
•
Plug 2
-
pin male wire harness into 2
-
pin female chassis
wire.
Prepare Exterior Escutcheon, Continued
3
HH
20
4
Install lever and tighten down the set screw.
•
Press lever onto spindle until it snaps into place.
•
Tighten set screw with allen wrench
AA
by turning CW
until set screw bottoms out against the spindle.
The escutcheon is now ready to install on the door.
KEY OVERRIDE ONLY!
Install KIK cylinder in lever.
1.
Insert the cup
#22
included in the unit box into the exterior spindle as shown.
2.
Install tailpiece
#21
included in unit box on the KIK cylinder (purchased separately) inline
with the pin bible as shown.
3.
Loosen set screw
#12
in lever
#8
with Allen wrench
AA
then remove the retaining plate
assembly
#12, 13
.
4.
Insert the cylinder into the lever
#8
followed by the retainer assembly
#12, 13
.
5.
Turn the set screw CCW until secure to keep the retaining plate in place.
6.
Insert the key for the cylinder, turn it 90°, and insert the lever onto the lock gently. Verify
the cam in the lock is clear for the now vertical tailpiece to engage. Make sure the tailpiece
engages the cam properly and does not get stuck. DO NOT FORCE THE LEVER.
7.
Once the lever locks onto the spindle, turn the key back to the home position and remove
it from the cylinder.
8.
Turn the set screw CW until it is tightened down against the spindle using Allen wrench
AA
provided.
22
21
8
12, 13
1
2
3, 4, 5
6
6
7
6
AA