EQ34 GRADE 1 CYLINDRICAL LOCK
INSTALLATION INSTRUCTIONS
I
-
LS02688
Rev 1, Rev Date: 01/12/2023
[27390107]
Page
6
of
7
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325
-
9995 www.hagerco.com
6
INSTALL EXTERIOR ESCUTCHEON
•
Install escutcheon onto door by guiding wires into wiring hole and the chassis and wires into chassis hole.
•
Make sure the retractor engages with the latch.
•
Be sure the wires lay in the space provided by the backplate louver so they don
’
t pinch against the door.
•
While holding the escutcheon flat against the door, plug interior mounting plate
#5
into wiring harness and stow
the wires in the area behind the chassis. Position the plate over the chassis and fasten down with (2)
CC
screws as
shown below. Make sure the escutcheon is vertical and flat against the door before tightening down the screws.
Install Lock on Door
1
INSTALL INTERIOR TRIM
•
Install interior spring cage
#3
with (2)
CC
screws.
•
Install interior rose
#2
by aligning grooves in rose and
spring cage.
•
Be sure lever retaining plate
#13
and set screw
#12
are
installed in lever
#7
.
•
Install lever
#7
using removal tool
BB
to start the lever.
Snap into place and then tighten lever set screw with
AA
Allen wrench.
2
CC
2
7
3
BB
AA
CC
5
