Date : 20/09/2012
6T 8206-02a
tebis touch panel Installer Manual
INTRODUCTION
11
A HEATING – HEATING device, for example:
General representation:
Detailed representation:
Comments:
-
To switch from the general representation to the detailed representation of a device, simply click on the image.
-
When starting up the tebis touch panel, the status of certain devices may be unknown.
2.3 Start-up
2.3.1
Safety instruction
The device must be installed only by a qualified electrician in accordance with the installation standards in force in your
country. Do not install this module outside the building.
Do not use sharp or pointed objects (such as pencils, pens, etc.) to control the device. This may damage the touch
surface.
Do not use sharp objects, acid products or solvents for cleaning. This may damage the device.
Use only a clean, soft, dry cloth for cleaning the touch screen (see chapter 4.1.1).
Only removable storage devices are supported by the connector on the front of the unit.
The undefined status will therefore be shown as follows:
-
? (question mark): indicates an unknown status.
-
--- (three dashes): indicates an unknown value.
For the detailed view, it is also
possible to display and adjust
the set point temperature.
For the heating, it is possible to
display the heating mode and
the room temperature.
The lower section of the display
is used to control the heating
mode.
